| Stereo Tool https://www.forums.stereotool.com/ |
|
| virtual audio cable Problem https://www.forums.stereotool.com/viewtopic.php?t=4773 |
Page 1 of 1 |
| Author: | Skoge [ Sun Apr 07, 2013 11:41 am ] |
| Post subject: | virtual audio cable Problem |
I have a problem with stereo tool and virtual audio cable. I get sometimes buffering, lags and outcomes. On my M Audio sound card I can fix a similar problem by setting buffering time up. But I did not seem able to find something in virtual audio cable control pernel. Can I do something? Dennis Skoglund |
|
| Author: | Bojcha [ Sun Apr 07, 2013 2:48 pm ] |
| Post subject: | Re: virtual audio cable Problem |
How you exactly use VAC in combination with your M-Audio and also what version ? |
|
| Author: | Skoge [ Sun Apr 07, 2013 2:54 pm ] |
| Post subject: | Re: virtual audio cable Problem |
I do not use VAC with M Audio card. But I've had the same error on an M Audio card. I could solve by putting the buffer up to 1024 kb, but I can not see a way to do it in VAC |
|
| Author: | Skoge [ Sun Apr 07, 2013 2:57 pm ] |
| Post subject: | Re: virtual audio cable Problem |
Version 4.12 |
|
| Author: | Bojcha [ Sun Apr 07, 2013 4:58 pm ] |
| Post subject: | Re: virtual audio cable Problem |
In VAC panel set worker threads "up to" - number of your phisycal cores, Prio to 31. set all cables to fixed 16bit and sample rate fixed what you need. Turn off Channel mixing, PortCls. Set fmt to "cable range". NC 1 to 2. |
|
| Author: | Skoge [ Sun Apr 07, 2013 5:33 pm ] |
| Post subject: | Re: virtual audio cable Problem |
Like this ? http://www.radiohlr.dk/wp/wp-content/up ... 04/VAC.png |
|
| Author: | Bojcha [ Sun Apr 07, 2013 9:22 pm ] |
| Post subject: | Re: virtual audio cable Problem |
- NC 1 to 2 - depth 16 to 16 - Up to = number of cpu cores - Samplerate, if you want 48 then set - 48 to 48 |
|
| Author: | hvz [ Mon Apr 08, 2013 10:34 am ] |
| Post subject: | Re: virtual audio cable Problem |
Just to check - you're not talking about the buffers in Stereo Tool getting empty after a (long) time? Because if it's that, you can enabled 'Synchronize to output' in the input sound card settings. This can occur because the VAC sample rates will never exactly match sound card sample rates. If you're not using an actual sound card this is no issue. |
|
| Author: | actionradio951 [ Fri May 31, 2013 4:39 pm ] |
| Post subject: | Re: virtual audio cable Problem |
I am using Audiotx to StereoTool Standalone to SoundBlaster Sound card to Transmitter. I think I am connecting it correctly but I am getting a double audio output. like an echo. any suggestions? |
|
| Page 1 of 1 | All times are UTC+02:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|
