Stereo Tool

Hi: sorry for m english..
i have lots of question

Question 1: why can't i read 'Stereo Tool and AM/FM transmitters' topic....Password is needed

Question 2: I have Esi Juli@..But i can't use for mpx output...I set 192 sample rate on Stereo Tool configuration...
i use left output for cable...Can you tell me with picture 'what is stereo tool sound card configuration'


Question 3: Latency is not important for me..I am using Virtual Audio Cable....Need i use ASIO?

Hello qsqs,

1 - should be solved now.

2 - I see a few things that are wrong. Most importantly: You are sending 2 (!) outputs to the same sound card: Normal output AND FM output. Either disable one (the Normal output), or send it to a different location.
And: Are you sure that you need the microphone input of the card?

3 -I don't think VAC works very well with ASIO. So if latency is not important, you could choose not to use it (I should mention though that I have seen issues with the Juli@ drivers for non-ASIO control).

BTW: Why do you use VAC when you have a Juli@? The Juli@ driver itself contains the same features....

İ dont use mic input.(wrong in picture)

İ use vac because i dont use line in...i use one pc. My sound is going directly automation software to mpx output( automation is SOLEA which doesnt suport dx)

How can i do non using vac?

Thanks

The Juli@ drivers have something like VAC built in. It's called DirectWire.

i am not using stereo tools yet...Also i want to ask a question

my output is working....I cant get a sound for streaming...(in stream program, all inputs,choices are tried)
how i can use Esi Julia Directwire?

To clear something. Do you want yo play music for streaming only or for streaming and FM transmitter ?

both of them...streaming and fm transmitter

ok..

- You need Virtual Audio Cables. (2 cables)
- In automation software set output VAC1
- In StereoTool (Standalone) select Input VAC1
- For Normal Output Select VAC2
- For FM transmitter output select Juli@ (Ch12) - Output from Juli@ goes into transmitter's (mpx input)
- Now On streaming software select input VAC2

Your Virtual Cable Control Panel should be adjusted like this: http://i.imgur.com/oZjBT.png

If this setup works for you, i will tell you another with Direct Wire, so you can 'hear' your automation software.

ps: Hope you have enough CPU power.

Or
Julia's out to FM transmitter.-

Select the cheap/unused onboard for normal output. On your stream encoder, set capture device the cheap card, but first select on "Recording" to capture from the stereo mix!

not good lef. VAC is "ideal" soundcard so it'll be always better from any soundcard for Normal Output.