Thanks Hans, When you release the new version, I can upgrade during the night to test it live
| Stereo Tool https://www.forums.stereotool.com/ |
|
| Stereo Tool 8.12 https://www.forums.stereotool.com/viewtopic.php?t=12543 |
Page 4 of 4 |
| Author: | hvz [ Thu Nov 10, 2016 2:08 pm ] |
| Post subject: | Re: Stereo Tool 8.12 |
Yup. Turns out that all the whole processing threads in 8.12 are NOT running at an elevated priority! Ok, updated now. I/O and gathering of data after processing is finished now runs at priority 2. Processing runs at priority 1. GUI runs at -1. Everything else runs at priority 0. Note: Actual ASIO I/O runs at a much higher priority (15 or even higher, depending on the ASIO driver). 1 and 2 appear to be enough though (I used 1 in 8.00 and before). In version 8.00, I/O and processing both ran at priority 1. But the changes in the framework (there was no separate gathering thread for example, and processing would never run simultaneously with I/O) there was no need for separate priorities for I/O and processing, there is now though. |
|
| Author: | timmywa [ Thu Nov 10, 2016 5:31 pm ] |
| Post subject: | Re: Stereo Tool 8.12 |
Hans, are you going to update 8.12 or just add these fixes to the next beta? |
|
| Author: | stef007 [ Thu Nov 10, 2016 9:18 pm ] |
| Post subject: | Re: Stereo Tool 8.12 |
Thanks Hans, When you release the new version, I can upgrade during the night to test it live
|
|
| Author: | hvz [ Fri Nov 11, 2016 11:55 am ] |
| Post subject: | Re: Stereo Tool 8.12 |
New beta: viewtopic.php?f=14&t=12785 |
|
| Author: | GuntherM [ Tue Nov 15, 2016 11:28 pm ] | ||
| Post subject: | Re: Stereo Tool 8.12 | ||
Uhm, just installed 64bit stand alone version of v8.12 and I get this :/
|
|||
| Author: | hvz [ Tue Nov 15, 2016 11:49 pm ] |
| Post subject: | Re: Stereo Tool 8.12 |
Quote: Uhm, just installed 64bit stand alone version of v8.12 and I get this :/
Does that reproduce when you start it again? If so, can you send me your settings?
|
|
| Author: | GuntherM [ Tue Nov 15, 2016 11:52 pm ] |
| Post subject: | Re: Stereo Tool 8.12 |
I unchecked LQ output and ticked it back on, seems the problem is solved. Strange, seems to run ok now. [edit] it's LQ output that cause the exception |
|
| Author: | katao [ Sun Nov 20, 2016 4:18 pm ] |
| Post subject: | Re: Stereo Tool 8.12 |
The version 8.12 the "FM Output > Calibration" don't work!!! Regard's |
|
| Author: | hvz [ Mon Nov 21, 2016 10:30 am ] |
| Post subject: | Re: Stereo Tool 8.12 |
Quote: The version 8.12 the "FM Output > Calibration" don't work!!!
Please try the latest beta (8.13). There it's fixed!
Regard's |
|
| Page 4 of 4 | All times are UTC+02:00 |
| Powered by phpBB® Forum Software © phpBB Limited https://www.phpbb.com/ |
|